Abstract

This paper proposes a grouped, reactive power optimization control strategy to maximize the active power output of a doubly-fed induction generator (DFIG) based on a large wind farm (WF). Optimization problems are formulated based on established grouped loss models and the reactive power limits of the wind turbines (WTs). The WTs in the WF are grouped to relieve computational burden. The particle swarm optimization (PSO) algorithm is applied to optimize the distribution of reactive power among groups, and a proportional control strategy is used to distribute the reactive power requirements in each group. Furthermore, the proposed control strategy optimizes the reactive power distribution between the stator and the grid side converter (GSC) in each WT. The proposed control strategy greatly reduces the number of variables for optimization, and increases the calculation speed of the algorithm. Thus, the control strategy can not only increase the active power output of the WF but also enable the WF to track the reactive power dispatching instruction of the power grid. A simulation of the DFIG WF is given to verify the effectiveness of the proposed control strategy at different wind speeds and reactive power references.

Highlights

  • This paper proposes a grouped reactive power optimization control strategy for large doubly-fed induction generator (DFIG) wind farm (WF), which is partly reported in PESA [21]

  • It divides the wind turbines (WTs) into several groups and uses the particle swarm optimization (PSO) algorithm to optimize the distribution of reactive power among groups

  • A simulated DFIG WF with two feeders was built on the MATLAB/Simulink

Read more

Summary

Introduction

Publisher’s Note: MDPI stays neutral with regard to jurisdictional claims in published maps and institutional affiliations. A novel active power dispatching strategy based on dynamic grouping of WTs is proposed to obtain smoother active power references in [16] This can enable WTs to track the dispatching instruction and alleviate the fatigue of WTs in order to achieve the reactive power requirements of the power grid and decrease the losses of the WF. This paper proposes a grouped reactive power optimization control strategy for large DFIG WFs, which is partly reported in PESA [21]. It divides the WTs into several groups and uses the PSO algorithm to optimize the distribution of reactive power among groups.

Losses Model of the Wind Farm
Losses Model of Transmission Network
Pcable
Grouped power flow model of DFIG
Power flow
Objective
Grouped Optimization Scheme
Grouped
Simulation Results
Case of WF
Case 1 Reactive Power of WF Remains Constant
The losses of WTs
11. The losses
12. The with different different control control strategies
Case 2 Reactive Power of WF Remains Change
16. Total losses of of WF
Conclusions

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.