Abstract

The planar edge termination techniques of junction termination extension (JTE) and offset field plates and field-limiting rings (OFP-FLR) were investigated and optimized using a two-dimensional device simulator TMA MEDICI. By experimental verification, a good consistency between simulation and experiment can be observed. The results show that the p-i-n diode with an optimized JTE edge termination can accomplish near ideal breakdown voltage and much lower leakage current. The breakdown voltage can be higher than 1800 V, which achieves more than 90 percent of ideal parallel plane junction breakdown voltage, and the leakage current density can be as low as 2X10/sup -4 /A/cm/sup 2/.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.