Optimisation of NO x reduction in advanced coal reburning systems and the effect of coal type ☆

Abstract

The advanced reburning process for NO x emission control was studied in a down-fired 20 kW combustor by evaluating the performance of 15 pulverised coals as reburning fuels. The proximate volatile matter contents of the coals selected ranged from around 4 to 40 wt% (as received) with elemental nitrogen contents from around 0.6 to 2.0 wt%. The effects of reburn fuel fraction, reburning zone residence time, ammonia agent injection delay time (relative to the reburn fuel and burnout air injection points) and the nitrogen stoichiometric ratio are reported in detail and the optimum configurations for advanced reburning, established as a function of operating condition and coal type. The experimental results show that advanced reburning can reduce NO x emissions up to 85%. The maximum benefits of advanced reburning over conventional reburning were observed at the lower reburn fuel fractions (around 10%). The results demonstrate that under advanced reburning conditions equivalent or higher levels of NO x reduction can be achieved while operating the reburn zone closer to stoichiometric conditions compared with conventional reburning operating at high reburn fuel fractions (20–25%). Thus the practical problems associated with fuel-rich staged operation can be reduced. The effect of coal properties on the advanced reburning performance was also investigated. As with conventional reburning, the fuel nitrogen content of the coal used was found to have little influence on the NO x reduction efficiency except at the highest reburn fuel fractions. There was, however, a strong correlation between the effectiveness of advanced reburning and the volatile content of the reburning fuels, which not only depended on the reburn fuel fraction, but also the mode (rich or lean) of advanced reburning operation. These parameters are mapped out experimentally to enable the best operating mode to be selected for advanced reburning as a function of the reburning fuel fraction and volatile content.