Optimal sizing and siting of renewable energy resources in distribution systems considering time varying electrical/heating/cooling loads using PSO algorithm

Abstract

ABSTRACTDistributed Generation (DG) sources based on Renewable Energy (RE) can be the fastest growing power resources in distribution systems due to their environmental friendliness and also the limited sources of fossil fuels. In general, the optimal location and size of DG units have profoundly impacted on the system losses in a distribution network. In the present article, the Particle Swarm Optimization (PSO) algorithm is employed to find the optimal location and size of DG units in a distribution system. The optimal location and size of DG units are determined on the basis of a multi-objective strategy as follows: (i) the minimization of network power losses, (ii) the minimization of the total costs of Distributed Energy Resources (DERs), (iii) the improvement of voltage stability, and (iv) the minimization of greenhouse gas emissions. The related distribution system was assumed to be composed of the fuel cells, wind turbines, photovoltaic arrays, and battery storages. The electrical, cooling, and heating loads were also considered in this article. The heating and cooling requirements of the system consist of time varying water heating load, space heating load, and space cooling load. In this study, the waste and fuel cell were used to produce the required heating and cooling loads in the distribution system. In addition, the absorption chiller was used to supply the required space cooling loads. A detailed performance analysis was carried out on 13 bus radial distribution system to demonstrate the effectiveness of the proposed methodology.