Abstract
In electrical discharge machining (EDM) process which is an advance and non-conventional technique, the selection of machining parameters for achieving high machining performance is an important; however, very problematic task. In the current manuscript it was aimed to ascertain optimal machining set-up of EDM process related with fine surface finish. The die-sinking EDM was carried out using the both polarities (positive and negative) of graphite electrode. The microstructure of the workpiece surface was investigated by scanning electronic microscopy. The negative polarity produces, on average, nearly double surface roughness than that with positive polarity. The surface microstructure is deteriorated as the discharge energy level increases for both polarities.
Sign-in/Register to access full text options 
Free) 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
