Abstract
This study intended to establish the optimal heat treatment conditions for the desired hardness and wear resistance property for the bimetal hammers developed by the authors. The objective of this study is to attain bimetal hammers that have a tough Cr–Ni alloyed steel shank and a high wear resistant high Cr cast iron head to replace conventional single alloy (high Mn steel) hammers. The results show that the optimal heat treatment condition obtained for the bimetal hammers is: destabilisation: 1000–1050°C for 2 h, quench: FAC and tempering: 480–500°C for 6 h. By employing this optimal heat treatment condition, the highest hardness value can be attained along with the best wear resistance property for the head portion and acceptable toughness for the shank portion. The microstructure of the head portion that corresponds to the optimal properties consists of eutectic M7C3 carbides, secondary M7C3 carbides, tempered martensite and almost nil retained austenite.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
