OPTIMAL CONSTRUCTION AND TECHNOLOGICAL SOLUTION FOR RECONSTRUCTION OF A CITY PIPELINE AND THE RESULTS OF ITS TESTS

Abstract

Purpose. To once again draw the attention of bridge owners and bridge experts to the problems of reconstruction of long-term bridges and on a concrete example of reconstruction of a rather problematic city overpass operated for more than 60 years to shows that with the optimal structural and technological solutions of the reconstruction received a restored bridge, and its operational and technical and economic indicators which according to the requirements of the National Building Norms completely correspond to the new bridge, but the reconstruction cost and the lead time are greatly reduced. Methodology. To achieve this purpose over the past ten years of operation of the overpass conducted three inspections and full-scale static tests. It is determined that most of the existing reinforced concrete structures, although defective and in need of repair, can be used for further operation after reconstruction, provided they are reinforced. Worn out non-repairable structures that needed to be replaced were also found. Results. According to these initial data, a reconstruction project was developed using scientific and technological structure developments of the Branch Research Laboratory 88 of Lviv Polytechnic National University for the reconstruction of bridges. The span structure has been expanded to 4 lanes from the size G-10.5 + 2 × 0.9 m to the new G-16.5 + 2 × 1.5 m in a combined way – symmetrical completion of two new beams with their support on the extended support and installation of a reinforced concrete extension board with cantilever overhangs 2.7 m long. The most damaged boundary beams were replaced with new ones, designed for normalized temporary loads A15 and NK-100. For further operation the other existing beams are reinforced in one of the least expensive ways – by changing the static scheme from the existing split to the new clamped on the supports frame-inseparable. A set of repair works is provided to ensure the normalized durability of the reconstructed overpass. The scientific novelty is to develop a method for determining the experimental Coefficients of Transverse Distribution of Bending Moments (CTDM) and external loads (CTD) based on the results of tests of the span structure. The possibility of applying the method of elastic supports for the spatial calculation of span structures with beams of different stiffness is confirmed. Practical significance. The use of optimal design solutions for the reconstruction of existing span structures: reinforced concrete billboard with large cantilever overhangs to expand and change the static scheme to strengthen the beams of span structures.