Optical study for springback prediction, thickness reduction and forces variations on single point incremental forming

Abstract

The goal of the present work is to present an experimental study regarding the influence of the main technological influence factors such as the vertical step and the punch diameter on the single point incremental forming process (SPIF). In this paper we estimate the influence of these two factors on springback, thickness reduction and forces. Both parameters were varied on two levels: (d) punch diameter 6 and 10 mm and (s) vertical step 0,1 and 0,5 mm. The experiments were done on experimental layout composed by a robot, a clamping system that contains the die’s lower part and the optical system.