Abstract
With an innovative optical characterization method, using high-temperature digital image correlation in combination with thermal imaging, the local change in strain and change in temperature could be determined during thermo-mechanical treatment of flat steel specimens. With data obtained by this optical method, the transformation kinetics for every area of interest along the whole measuring length of a flat specimen could be analyzed by the generation of dilatation curves. The benefit of this innovative optical characterization method compared to a dilatometer test is that the experimental effort for the design of a tailored component could be strongly reduced to the investigation of only a few tailored thermo-mechanical processed specimens. Due to the implementation of a strain and/or temperature gradient within the flat specimen, less metallographic samples are prepared for hardness analysis and analysis of the microstructural composition by scanning electron microscopy to investigate the influence of different process parameters. Compared to performed dilatometer tests in this study, the optical method obtained comparable results for the transformation start and end temperatures. For the final design of a part with tailored properties, the optical method is suitable for a time-efficient material characterization.Graphical
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
