Abstract
Nanostructured gold/tungsten trioxide (Au/WO3) thin films based gasochromic sensors have been developed and investigated towards hydrogen (H2) at low concentrations. Using a novel wet chemical method, atomically precise gold (Au) nanoclusters were deposited onto tungsten trioxide (WO3) films supported on a quartz substrate. The Au/WO3 based sensors exhibited change in gasochromic properties upon exposure to H2 in the visible-NIR (800–1000nm) range. The total absorbance in this range increased by approximately 2.5%, when exposed to H2 gas (0.06%) balanced in synthetic air at an operating temperature of 200°C. The micro-structural properties of the films were studied via energy-dispersive X-ray spectroscopy (EDX), transmission electron microscopy (TEM), and scanning electron microscopy (SEM). EDX analysis of the Au/WO3 films on quartz substrates shows the presence of strong tungsten (W) and oxygen (O) peaks, which indicates that the films are mainly consisted of WO3. TEM investigation showed that the synthesised Au nanoparticles have average diameters of 2–5nm after deposition. SEM investigations revealed agglomeration of the Au phosphine [Au9(PPh3)8(NO3)3] clusters to form nanoparticles on top of WO3 layer. At optimum operating temperature (200°C), fast response (<2min) and recovery in conjunction with a stable baseline occurs.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.