Operational experience and test results in the adaptive test section of the DLR transonic tunnel

Abstract

AbstractThe transonic facility of DLR Göttingen (TWG) has been modernised with respect to an improved flow quality and flow simulation, as well as to the logistics of exchangeable test sections, operational reliability and productivity. It is presently equipped with a Laval nozzle for supersonic flow measurements, a perforated test section (6% open, 60° slanted holes) for transonic measurements, and a two-dimensional adaptive test section for subsonic measurements. The latter can perform two-dimensional adaptive tests on wing profiles, using the Cauchy integral formula for wall adaptation, as well as two-dimensional wall adaptation for three-dimensional models, utilising the Wedemeyer/Lamarche procedure, also known as the VKI method. For both cases, it is shown that the wall adaptation was successful. The 3D force results compare quite well to test results from the perforated test section, as well as to nominally interference-free results. The pressure distribution from the wing profile tests compare quite well to theoretical calculations. In the course of windtunnel modernisation, the transonic facility of DLR Göttingen has been equipped with the new software system DeAs for data acquisition and control of experimental facilities. In this environment the wall adaptation programs had to be implemented. Before adjusting the computed wall shape, it has to be controlled in the loop for sufficient accuracy and tolerable bending stresses. A simplified finite element method — also taking into account the pressure loads at the wall — is used for this purpose. The simplified approach has been checked against more detailed computations using ANSYS and NASTRAN.