Abstract
AbstractTo obtain accurate prediction of service performance and service life of polymers and to optimize the processing parameters, a modified online measurement was used to measure the pressure–volume–temperature (PVT) properties of polymers under certain processing conditions. The measurement was based on an injection molding machine, and it was used to obtain the PVT data of polymers directly with a special testing mold under normal processing conditions. The PVT properties of a semicrystalline polymer, polypropylene, were measured through both an online testing mold and a conventional piston–die dilatometer. The PVT properties were correlated by a modified two‐domain Tait equation of state. The differences between the two groups of PVT data measured were investigated, and relative differences, especially in the rubbery state because of different cooling or heating measuring modes and sample forms, were observed. Numerical simulations of injection‐molding processes were carried out by Moldflow software with both of the types of PVT data. The resulting online PVT data exhibited improvement in the accurate prediction of shrinkage and warpage. © 2010 Wiley Periodicals, Inc. J Appl Polym Sci, 2010
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
