Abstract
System identification is an inherently iterative process. Yet, limited attempts have been made so far to implement the whole identification loop in a single device. This paper discusses the difficulties of the task and presents a solution based on a Matlab toolbox and a set of virtual instruments. During the identification session the obtained models may call for refinement or validation by new experiments. Using this integrated software-hardware tool these subsequent experiments can be accomplished on-line with the identification procedure. As a demonstration, the modeling of a notch filter is described. The universal applicability of this solution is believed to be guaranteed by the modular architecture of virtual instrumentation and the general definition of the software interface developed. The interface allows combining Matlab-based identification packages with virtual instruments or pure hardware interfaced to Matlab.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.