Abstract
Dimethyl ether (DME) has been considered as a potential hydrogen carrier used in fuel cells; it can also be consumed as a diesel substitute or chemicals. To develop the technique of DME synthesis, a bifunctional Cu–ZnO–Al2O3/ZSM5 catalyst is prepared using a coprecipitation method. The reaction characteristics of DME synthesis from syngas at a high space velocity of 15,000mL (gcath)−1 are investigated and the effects of reaction temperature, pressure, CO2 concentration and ZSM5 amount on the synthesis are taken into account. The results suggest that an increase in CO2 concentration in the feed gas substantially decreases the DME formation. The optimum reaction temperature always occurs at 225°C, regardless of what the pressure is. It is thus recognized that the DME synthesis is governed by two different mechanisms when the reaction temperature varies. At lower reaction temperatures (<225°C) the reaction is dominated by chemical kinetics, whereas thermodynamic equilibrium is the dominant mechanism as the reaction temperature is higher (>225°C). For the CO2 content of 5vol.% and the pressure of 40atm, the maximum DME yield is 1.89g (gcath)−1. It is also found that 0.2g of ZSM5 is sufficient to be blended with 1g of the catalyst for DME synthesis.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.