One Year Primary Patency of Infrapopliteal Angioplasty Using Drug- Eluting Balloons: Single Center Experience at King Hussein Medical Center.

Abstract

Objective:Conventional percutaneous transluminal angioplasty (PTA) for long lesions in the below-the-knee (BTK) arteries in patients presenting with critical limb ischemia (CLI) has high restenosis rates at 1 year. Our goal is to evaluate whether paclitaxel drug-eluting balloons (DEB) have higher 1 year primary patency rates compared to conventional PTA.Methods:This is a single-center, prospective, randomized trial that was conducted from June 2013 to December 2015. The aim of the study was to compare 1 year primary patency rates of DEB and PTA in BTK arteries in CLI patients. Inclusion criteria were patients presenting with CLI (Rutherford class 4 or greater), stenosis or occlusion ≥30 mm of at least one tibial artery, and agreement to 12-month evaluation. Exclusion criteria were life expectancy <1 year, allergy to paclitaxel, and contraindication to combined antiplatelet treatment. Follow-up was performed by clinical assessment, ankle brachial pressure index, Doppler ultrasound imaging, and conventional angiogram if indicated. Primary end point was 1 year primary patency, and secondary end points were target lesion revascularization (TLR) and major amputation. Statistical analysis was performed using Fischer's exact test.Results:Ninety-three patients with 106 lesions in the BTK arteries were enrolled in this study. One year primary patency was achieved in 26 (65%) and seven (17%) in the DEB and PTA groups (P = 0.006), respectively. TLR was performed in nine lesions (23%) and 29 lesions (71%) in DEB and PTA groups (P = 0.009), respectively. Major amputations occurred in one limb (2%) and two limbs (4%) in DEB and PTA groups (P = 0.6), respectively.Conclusion:Paclitaxel DEB has significantly higher 1 year primary patency rate associated with significantly less TLR than conventional PTA, following endovascular recanalization of BTK arteries in patients presenting with CLI.