One step hydrogenation–esterification of model compounds and bio-oil to alcohols and esters over Raney Ni catalysts

Abstract

Acids, aldehydes, ketones and phenols, which are the main components of bio-oil, have negative effects on the properties. In this paper, the mixture of acetic acid, furfural, hydroxyacetone, ethanediol, phenol and water were chosen as hybrid model compounds of bio-oil (MCB). To convert these compounds into stable and combustible oxygenated organics (alcohols and esters), one step hydrogenation–esterification (OHE) was carried out over Raney Ni catalyst (RN) and Mo, Sn, Fe, Cu modified Raney Ni catalysts (RNs) in the presence of methanol. 100% conversions of furfural and hydroxyacetone were achieved over RNs with high selectivity to desired products. The acetic acid conversion was only 35.1% with no methanol addition, while within 6g/8g methanol/MCB addition, the conversion of acetic acid increased to 81.1%. The esterification activity of alcohols was followed by methanol>tetrahydrofurfuryl alcohol (THFA), the hydrogenation product of furfural>ethanediol. Among the RNs, the addition of Fe catalyst restrained the aqueous-phase reforming of methanol and promoted the esterification of methanol and acetic acid. The Mo–RN showed the most favorable performance in the hydrogenation of phenol among the RNs. But the RN modified by both Fe and Mo did not give a good performance. After the OHE of light fraction of raw bio-oil over Mo–RN, there was no ketone & aldehyde detected and the contents of acids and phenols decreased from 49.04% and 7.35% to 8.21% and 3.84%. The conversion of acids could reach to 85.01% which was nearly to the conversion of acetic acid in MCB. The contents of alcohols and esters increased from 5.79% and 4.74% to 53.61% and 33.66%. The content of stable and combustible oxygenated organics reached to 87.27% after OHE of light fraction of raw bio-oil.