Abstract
Palladium–copper (PdCu) alloy layers with 150 nm thickness were prepared by one-step electroplating on both sides of a vanadium foil. The entire process, including pretreatment, washing, and electroplating, was complete in <5 min. The PdCu layer had a high surface coverage and almost completely covered the vanadium foil. The composition difference between the center and the edges was within 3 at%, and the alloy composition was controlled to nearly the target composition (50:50). Peel tests revealed that the as-electroplated layer had sufficient adhesion for practical applications. XRD analysis confirmed the successful formation of a face-centered cubic (FCC) PdCu alloy. In-situ XRD analysis performed under a hydrogen atmosphere revealed the structural change of PdCu from FCC to body-centered cubic (BCC) immediately after the temperature reached 300 °C. The hydrogen permeability of electroplated PdCu/V/PdCu at 200–300 °C (1–3 × 10−8 mol m−1 s−1 Pa−1/2) was considerably higher than that of the 10 μm-thick electroplated BCC PdCu.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
