One-pot synthesis of Li3xLa2/3−xTiO3/PVA composite with high tunable electrical attributes governed by the Li+ content

Abstract

The primary goal of this study is to elucidate the structural and electrical characteristics, alongside potential applications, of ceramic-polymeric composites. These composites are achieved by incorporating lithium-lanthanum titanates (Li3xLa2/3−xTiO3 - LLTO) into a polyvinyl alcohol polymeric matrix (PVA). The synthesis of lithium-lanthanum titanates occurred through high-energy ball milling method. Then, three types of composites were produced using the solvent casting method: a sample of pure Poly (vinyl alcohol) polymer (PVA), a second PVA composite with the addition of La0·59Li0·24TiO3 (Li-0.24) and a third sample with La0·56Li0·33TiO3 (Li-0.33). SEM and AFM analyzes revealed notable changes in the morphology and 3D spatial patterns of the films upon incorporating lithium-lanthanum titanates into the PVA matrix. The PVA film presents a topography featuring a more evenly distributed range of topographic heights, indicating a smoother surface structure. With varying LLTO content, the morphology of the PVA composite underwent changes. The lower roughness of the PVA surface is evident from its measured average roughness value (Ra = 1.9 ± 0.5 nm). Upon incorporating LLTO, the surfaces displayed increased roughness, measuring specifically at 40.1 ± 7.3 nm (Li-0.24) and 22.7 ± 5.5 nm (Li-0.33). Notably, there was an approximately 43 % reduction in the average roughness value from Li-0.24 to Li-0.33. The analysis by Raman allowed the identification of functional groups of the PVA polymeric chain, in addition to the presence of some vibrational modes related to the structure of lithium-lanthanum titanates for the sample with the highest content of Li+ ions (Li-0.33). Finally, the sample Li-0.33 showed the lowest value of electrical resistance (67 kΩ) and of phase angle (16°), compared to the PVA (100 MΩ and 90°). These results show that the presence of the LLTO changed the insulating behavior of the PVA matrix changed and improved potential to electronic applications.