One-Pot Fabrication of Nanocomposites Composed of Carbon Nanotubes and Alumina Powder Using a Rotatable Chemical Vapor Deposition System.

Abstract

The fabrication of multi-dimensional nanocomposites has been extensively attempted to achieve synergistic performance through the uniform mixing of functional constituents. Herein, we report a one-pot fabrication of nanocomposites composed of carbon nanotubes (CNTs) and Al2O3 powder. Our strategy involves a synthesis of CNTs on the entire Al2O3 surface using a rotatable chemical vapor deposition system (RCVD). Ehylene and ferritin-induced nanoparticles were used as the carbon source and wet catalyst, respectively. The RCVD was composed of a quartz reaction tube, 5.08 cm in diameter and 150 cm in length, with a rotation speed controller. Ferritin dissolved in deionized water was uniformly dispersed on the Al2O3 surface and calcinated to obtain iron nanoparticles. The synthesis temperature, time, and rotation speed of the chamber were the main parameters used to investigate the growth behavior of CNTs. We found that the CNTs can be grown at least around 600 °C, and the number of tubes increases with increasing growth time. A faster rotation of the chamber allows for the uniform growth of CNT by the tip-growth mechanism. Our results are preliminary at present but show that the RCVD process is sufficient for the fabrication of powder-based nanocomposites.