Abstract
We discuss the design of one-port surface acoustic wave (SAW) resonators using substrates with a partial or total degree of directivity, that is, the natural single-phase unidirectional transducer (N-SPUDT) effect. A general design method gives a resonance when all three frequencies (the required resonance frequency and the Bragg frequencies) are different. A second method has been derived from the resonance condition for a symmetrical substrate. Two further methods incorporate lamda/4 gaps. The capacitance ratio is presented as a function of the phase of the electrode reflection coefficient. The simulations use data for the N-SPUDT orientation of langasite. The reflection coefficient for Al electrodes has been calculated from finite element modeling (FEM) analysis. The approximate perturbation theory is found to agree well for small film thickness (h/lamda < 2%). The phase of the reflection coefficient is typically 150 degrees, not quite the ideal value of 180 degrees. Measurements on resonators using Al and Cu films are presented.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
