Abstract

We characterized the pharmacokinetics of onartuzumab (MetMAb) in animals and determined a concentration-effect relationship in tumor-bearing mice to enable estimation of clinical pharmacokinetics and target doses. A tumor growth inhibition model was used to estimate tumoristatic concentrations (TSC) in mice. Human pharmacokinetic parameters were projected from pharmacokinetics in cynomolgus monkeys by the species-invariant time method. Monte Carlo simulations predicted the percentage of patients achieving steady-state trough serum concentrations (Ctrough ss) ≥TSC for every 3-week (Q3W) dosing. Onartuzumab clearance (CL) in the linear dose range was 21.1 and 12.2 mL/d/kg in mice and cynomolgus monkeys with elimination half-life at 6.10 and 3.37 days, respectively. The estimated TSC in KP4 pancreatic xenograft tumor-bearing mice was 15 μg/mL. Projected CL for humans in the linear dose range was 5.74 to 9.36 mL/d/kg with scaling exponents of CL at 0.75 to 0.9. Monte Carlo simulations projected a Q3W dose of 10 to 30 mg/kg to achieve Ctrough ss of 15 μg/mL in 95% or more of patients. Onartuzumab pharmacokinetics differed from typical bivalent glycosylated monoclonal antibodies with approximately 2-times faster CL in the linear dose range. Despite this higher CL, xenograft efficacy data supported dose flexibility with Q1W to Q3W dose regimens in the clinical setting with a TSC of 15 μg/mL as the Ctrough ss target. The projected human efficacious dose of 10 to 30 mg/kg Q3W should achieve the target TSC of 15 μg/mL. These data show effective pharmacokinetic/pharmacodynamic modeling to project doses to be tested in the clinic.

Highlights

  • The importance of pharmacokinetic and pharmacodynamic modeling and simulation in all phases of drug development has been recognized [1, 2]

  • Onartuzumab pharmacokinetics differed from typical bivalent glycosylated monoclonal antibodies with approximately 2-times faster CL in the linear dose range

  • The projected human efficacious dose of 10 to 30 mg/kg Q3W should achieve the target tumoristatic concentrations (TSC) of 15 mg/mL. These data show effective pharmacokinetic/pharmacodynamic modeling to project doses to be tested in the clinic

Read more

Summary

Introduction

The importance of pharmacokinetic and pharmacodynamic modeling and simulation in all phases of drug development has been recognized [1, 2]. Authors' Affiliations: Departments of 1Pharmacokinetic and Pharmacodynamic Sciences, 2Translational Oncology, 3Bioanalytical Sciences, 4Biochemical and Cellular Pharmacology, and 5Portfolio Management and Operations, Genentech, Inc., South San Francisco; 6Quantitative Solutions, Menlo Park; 7Medivation, Inc., San Francisco; and 8Celgene, San Diego, California. Note: Supplementary data for this article are available at Clinical Cancer Research Online (http://clincancerres.aacrjournals.org/). Peterson were employed by Genentech during their involvement in this study

Methods
Results
Discussion
Conclusion

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.