Abstract
Unconventional machining like wire electric discharge machining/cutting (WEDM/WEDC) seems to be a better choice for machining/cutting the metal matrix composites (MMCs) because it offers easy control and has the capability of machining intricate complex shapes. But wire breakage in the WEDM/WEDC process decreases the machining accuracy and the quality of the machined surface. This paper describes the effect of four input process parameters (i.e., servo voltage, pulse-on time, pulse-off time, and wire feed rate) on wire breakage frequency and the microstructure of the cut surface during WEDC of SiCp/6061 Al MMC. An optimum range of input parameters has been bracketed as the outcome of this work for determining the effects of input process parameters on the average cutting speed, material removal rate, and surface roughness during WEDC of SiCp/6061 Al MMC. This range of input parameters can also be used for carrying out further research to develop the models for WEDC of SiCp/6061 Al MMC and to optimize the WEDC parameters for smooth cutting.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: The International Journal of Advanced Manufacturing Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
