Abstract
This study presents the results of research on the condition of low content polycrystalline cubic boron nitride cutting tools (cBN-L) when finish turning of hardened AISI D2 tool steel. The least changes in the condition of wedges throughout the investigated turning feeds were observed for the composite cBN020 whereas the highest wear intensity was found for the composite cBN200. For all researched cutting materials, abrasive wear, as well intense adhesion were observed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
