On the way to increase osseointegration potential: Sequential SI-ATRP as promising tool for PEEK-based implant nano-engineering

Abstract

In the search of the ideal bone implant material, surface initiated atom transfer radical polymerization (SI-ATRP) techniques were successfully employed to modify the polyetheretherketone (PEEK) surface with complex architecture nanolayers featuring hydrophilic poly(2-(dimethylamino)ethyl methacrylate) (PDMAEMA) or poly(2-hydroxyethyl methacrylate) (PHEMA) branches. As a result, polymer layers with height up to over 300 nm were synthesized to decrease the water contact angle from 92.8° to 23.0°. In-depth analysis of layer topography, structure and elemental composition realized with atomic force microscopy (AFM), attenuated total reflectance Fourier transform infrared spectroscopy (ATR-FTIR), time-of-flight secondary ions mass spectroscopy (TOF-SIMS) and X-ray photon spectroscopy (XPS) confirmed successful surface modification. Additionally, to demonstrate the applicability of proposed PEEK functionalization, the biomineralization assay in simulated body fluid (SBF) solution was conducted. The high density of hydroxyl and amine groups in branched polymer brushes structure enhanced the rate of hydroxyapatites (HAp) formation substantially. Compared to untreated PEEK, modification with polymer brushes resulted in the creation of cauliflower-like structures with high specific surface area and Ca/P ratio equal to 1.83–1.87 for PEEK grafted with brushes composed of PHEMA backbone segment and PDMAEMA or PHEMA as block polymer branches (PEEK-g-PHEMA-g-PDMAEMA or PEEK-g-PHEMA-g-PHEMA) after 2 weeks. Finally, the process of the hydroxyapatite formation and increase of the layer thickness in a range of 14 days to 6 weeks of immersion in SBF was thoroughly visualized by scanning electron microscopy (SEM).