On the uses of special crack tip elements in numerical rock fracture mechanics

Abstract

Numerical methods such as boundary element methods are widely used for the stress analysis in solid mechanics. These methods are also used for crack analysis in rock fracture mechanics. There are singularities for the stresses and displacements at the crack tips in fracture mechanics problem, which decrease the accuracy of the numerical results in areas very close to the crack ends. To overcome this, higher order elements and isoperimetric higher order elements have been used. Recently, special crack tip elements have been proposed and used in most of the numerical fracture mechanics models. These elements can drastically increase the accuracy of the results near the crack tips, but in most of the models only one special crack tip element has been used for each crack end. In this study the uses of higher order crack tip elements are discussed and a higher order displacement discontinuity method is used to investigate the effect of these elements on the accuracy of the results in some crack problems. The useful shape functions for two special crack tip elements, are derived and given in the text and appendix for both infinite and semi-infinite plane problems. In this analysis both Mode I and Mode II stress intensity factors are computed . Some example problems are solved and the computed results are compared with the results given in the literature. The numerical results obtained here are in good agreement with those cited in the literature. For the curved crack problem, the strain energy release rate, G can be calculated accurately in the vicinity of the crack tips by using the higher order displacement discontinuity method with a quadratic variation of displacement discontinuity elements and with two special crack tip elements at each crack end.