On the Use of Surfactant‐Complexed Chitosan for Toughening 3D Printed Polymethacrylate Composites

Abstract

AbstractThis work reports a simple approach to prepare toughened 3D‐printed polymethacrylate (PMA) composites using surfactant‐modified chitosan (SMCS) particles at loadings between 2–10 wt%. Chitosan (CS) is modified with anionic surfactant, sodium dodecyl sulfate, via ionic complexation to facilitate compatibility and dispersion of CS to PMA matrix by non‐covalent interactions between the components. The study successfully demonstrates high‐accuracy 3D printing of composites with significant improvements in the overall mechanical properties. The composite with the best loading of 8 wt% SMCS shows a tensile modulus of 1.23 ± 0.05 GPa, a tensile strength at 49.8 ± 0.96 MPa, a yield stress at 33.3 ± 1.48 MPa, and a strain‐at‐failure 10.3 ± 0.61%, which are 45%, 40%, 32%, and 68% higher than neat PMA, respectively. This provides a significant improvement in toughness at 4.92 ± 0.55 MJ m−3 for the composite, 184% higher than that of neat PMA. The marked increase in toughness is due to enhanced filler‐matrix interactions which improve the ability of the 3D printed composite to absorb energy under tensile load. The results from this work provide new understandings into the strategies for design and preparation of stereolithography 3D printed materials reinforced with toughening fillers from renewable resources.