On the relationship between cutting forces and anisotropy features in the milling of LPBF Inconel 718 for near net shape parts

Abstract

The versatility and potential applications of additive manufacturing have accelerated the development of additive/subtractive hybrid manufacturing methods. LPBF processes are exceptionally efficient at producing complex-shaped, thin-walled, hollow, or slender parts; however, finishing machining operations are necessary to ensure part assembly and surface quality. Rapid solidification during LPBF processes generates columnar grain structures in alloys. This is associated with crystalline textures and anisotropy, and therefore, mechanical properties are highly dependent on space directions, thus affecting cutting force and its variability.In this study, theoretical and experimental analyses examined the effects of LPBF parameters on cutting forces and the anisotropy of alloys. Therefore, an oblique cutting Taylor based model was proposed to quantify the crystallographic effects on the shear strength. For this, the tool geometry, tool position, and laser scanning strategy were considered along with the microstructures, crystallographic textures and grain morphologies of two samples with different layer thicknesses (low-volumetric energy density (VED) and high-VED) using scanning electron microscopy and electron backscatter diffraction. Peripheral milling operations had been performed under 54 experimental conditions to evaluate the interactions between the machining parameters along with the layer thickness and the microstructural characteristics of printed alloys. The analysis revealed a significant interaction between the direction of the plane of the shear band and the grain orientation along the main axis. Three milling configurations were evaluated. The effects of the layer thickness on the evolution of the cutting force were elucidated. Additionally, the low-VED sample exhibited higher anisotropy in the cutting force compared to the high-VED one. The anisotropy in the latter corresponds to a high, dense <001> ring-like texture; however, the crystallographic effect is lower in the low-VED sample. A good correlation between the cutting force fluctuation and the predicted Taylor factor was obtained. Lastly, the grain boundary density was acceptably correlated with the level of cutting force for both the printed cases.