Abstract

An improved interpolation method is presented based on B-spline curve back calculation which regards data points as control points. First, a B-spline surface reconstruction is done, and a favorable condition for real-time interpolation can be provided for NC machining. Then, by prejudging the trajectory feedrate, the tangent vectors of spline curve junction can be calculated, which can be used to establish the spline curve equations based on time. At last, with the equations mentioned above, the trajectory and feedrate profile can be generated simultaneously by the improved interpolation algorithm. An error analysis is also discussed and the feasibility of the improved algorithm is verified by the simulation results.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.