Abstract

This article demonstrates that ionizing radiation induces simultaneous crosslinking and scission in poly(trimethylene carbonate-co-d-lactide) diblock and random copolymers. Copolymer films were electron-beam (EB) irradiated up to 300 kGy under anaerobic conditions and subsequently examined by evaluation of their structure (FT-IR, NMR), molecular weight, intrinsic viscosities, and thermal properties. Radiation chemistry of the copolymers is strongly influenced by the content of ester linkages of the lactide component. At low lactide content, crosslinking reaction is the dominant one; however, as the lactide ratio increases, the ester linkages scission becomes more competent and exceeds the crosslinking. Electron paramagnetic resonance (EPR) measurements indicate that higher content of amorphous carbonate units in copolymers leads to a reduction in free radical yield and faster radical decay as compared to lactide-rich compositions. The domination of scission of ester bonds was confirmed by identifying the radiolytically produced alkoxyl and acetyl radicals, the latter being more stable due to its conjugated structure.

Highlights

  • Biodegradable polymers are excellent solutions for a wide range of applications, including those in biomedical and pharmaceutical fields

  • A series of diblock and random copolymers of poly(trimethylene carbonate) (PTMC) and poly(d-lactic acid) (PDLA) was synthesized according to procedures described above

  • Molecular weights of diblock copolymers were of standard level that can be obtained by sequential polymerization, the anticipated molecular weights of random copolymers were at similar level

Read more

Summary

Introduction

Biodegradable polymers are excellent solutions for a wide range of applications, including those in biomedical and pharmaceutical fields. Aliphatic polyesters of lactides and poly(trimethylene carbonate) (PTMC) have been extensively investigated due to their favorable properties, such as toxicological safety, controlled biodegradability and, if blended or copolymerized, tailorable mechanical properties [1,2,3]. Poly(lactic acid) (PLA) is a well-known typical biodegradable and biocompatible polymer, which is commonly produced from renewable resources [4]. This rigid polymer is utilized in load-bearing implantable medical devices and drug release matrices. Its poor thermal stability and deficient mechanical properties (high stiffness) limit the area of PLA application [7,8]. To improve heat stability and Polymers 2018, 10, 672; doi:10.3390/polym10060672 www.mdpi.com/journal/polymers

Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call