On the low-frequency elastic response of Pierre Shale during temperature cycles

Abstract

SUMMARYTemperature affects elastic rock properties but is less-studied and thus less-understood than pressure and stress. Thermal effects on dispersion are experimentally observed herein from seismic to ultrasonic frequencies: Young’s moduli and Poisson’s ratios plus P- and S-wave velocities are determined by forced oscillation (FO) from 1 to 144 Hz and by pulse transmission at 500 kHz. Despite being the dominant sedimentary rock type, shales receive less experimental attention than sandstones and carbonates. To our knowledge, no other FO studies on shale at above ambient temperatures exist. Temperature fluctuations are enforced by two temperature cycles from 20 via 40 to 60 °C and vice versa. Measured rock properties are initially irreversible but become reversible with increasing number of heating and cooling segments. Rock property sensitivity to temperature is likewise reduced. It is revealed that dispersion shifts towards higher frequencies with increasing temperature (reversible if decreased), Young’s moduli and P-wave velocity maxima occur at 40 °C for frequencies below 56 Hz, and S-wave velocities remain unchanged with temperature (if the first heating segment is neglected) at seismic frequencies. In comparison, ultrasonic P- and S-wave velocities are found to decrease with increasing temperatures. Behavioural differences between seismic and ultrasonic properties are attributed to decreasing fluid viscosity with temperature. We hypothesize that our ultrasonic recordings coincide with the transition-phase separating the low- and high-frequency regimes while our seismic recordings are within the low-frequency regime.