Abstract
The stiffness of soils depends on the state of stress. Therefore, the velocity of wave propagation can be used to assess the state of stress and its changes. Indeed, given sufficient data, measurements can be inverted to produce a tomographic image of the stress field. A preliminary study of this approach was conducted with simulated data and is summarized briefly. Results of an experimental study are then presented. Three common geotechnical systems were tested: a footing, a moving surface load, and a retaining wall. Calculated velocity changes are compared with predicted velocity changes, with stress changes being estimated by classical analytical solutions. Good agreement is found in the three cases. The need for accuracy in travel-time measurements, difficulties in tomographic imaging, and the propagation of uncertainty from inverted velocities to stresses are discussed. Key words : geophysical methods, tomography, wave propagation, stress, retaining wall, footings.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.