Abstract
The characteristics of the intervariant boundary network that resulted from the $$\beta \to \alpha^{\prime}$$ martensitic phase transformation in a Ti–6Al–4V alloy were studied using the crystallographic theories of displacive transformations, five-parameter grain boundary analysis and triple junction analysis. The microstructure of Ti–6Al–4V martensite consisted of fine laths containing dislocations and fine twins. The misorientation angle distribution revealed four distinct peaks consistent with the intervariant boundaries expected from the Burgers orientation relationship. The phenomenological theory of martensite predicted four-variant clustering to have the lowest transformation strain among different variant clustering combinations. This configuration was consistent with the observed Ti–6Al–4V martensitic microstructure, where four-variant clusters consisted of two pairs of distinct V-shape variants. The $$63.26^\circ /[\overline{10}\, 5\, 5\, \overline{3}]_{{\alpha^{\prime}}}$$ and $$60^\circ /[1\, 1\, \overline{2}\, 0]_{{\alpha^{\prime}}}$$ intervariant boundaries accounted for ~ 38% and 33% of the total population, respectively. The five-parameter boundary analysis showed that the former had a twist character, being terminated on the $$(\overline{3}\, 2\, 1\, 0)_{{\alpha^{\prime}}}$$ plane, and the latter revealed a symmetric tilt $$(1\, 0\, \overline{1}\, 1)_{{\alpha^{\prime}}}$$ boundary plane. The $$63.26^\circ /[\overline{10}\, 5\, 5\, \overline{3}]_{{\alpha^{\prime}}}$$ and $$60^\circ /[1\, 1\, \overline{2}\, 0]_{{\alpha^{\prime}}}$$ had the highest connectivity at triple junctions among other intervariant boundaries. Interestingly, the boundary network in Ti–6Al–4V martensite was significantly different from the commercially pure Ti martensite, where only $$60^\circ /[1\, 1\, \overline{2}\, 0]_{{\alpha^{\prime}}}$$ intervariant boundaries largely were found at triple junctions due to the formation of three-variant clustering to minimize the transformation strain. This difference is thought to result from a change in the martensitic transformation mechanism (slip vs twinning) caused by the alloy composition.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.