On the fatigue life of the single spot-welded joint under the two-step repeating loads. Comparison of results for mild steel and those for high strength steel: Satoh, T., Abe, H., Yokomine, T. and Nakaoka, T. Trans. Jpn Weld. Soc. (Apr. 1993) 24 (1), 3–9

Abstract

As an application to predict and mitigate the out-of-plane welding distortion by elastic FE analysis based on the inherent deformation theory, a panel structure of a pure car carrier ship is considered. The inherent deformations of different types of welded joints included in this ship panel structure are evaluated beforehand using thermal elastic plastic FE analysis. Applying idealized boundary condition to focus on the local deformation, elastic FE analysis shows that the considered ship panel structure will buckle near the edge and only bending distortion is dominant in the internal region. In order to mitigate out-of-plane welding distortion such as buckling and bending, straightening using line heating is employed. In the internal region, only inherent bending with the same magnitude as welding induced inherent bending is applied on the opposite side of welded joints (fast moving torch). On the other hand, only in-plane inherent strain produced by line heating is introduced to the edge region to correct buckling distortion (slow moving torch). The magnitude of out-of-plane welding distortion in this ship panel structure can be minimized to an accepted level.