On the design of piezoelectric actuator for 1D MEMS scanning mirror applications

Abstract

This study presents the design, implementation, and characterization of 1D resonant type micro-electro-mechanical-systems (MEMS) piezoelectric scanning mirrors with different actuator designs to investigate their influences on the figure of merits (FoMs) for automotive light detection and ranging application. The MEMS scanning mirrors are driven by lead zirconate titanate (PZT) thin film in this study owing to its outstanding piezoelectric properties. Three different beam-type piezoelectric actuators are designed, including the reference meander straight-beam actuator design, and the proposed meander curved-beam and straight-curved tapered beam actuator designs. Simulations show the scan angle enhancement for two proposed designs, yet the resonant scanning frequency of meander curved-beam design dropped to below the 2 kHz requirement. To evaluate the designs, scanning mirrors with two proposed actuators are fabricated and tested. Measurements show that the resonant frequencies for the two proposed MEMS scanning mirrors are 1735 Hz and 2578 Hz, respectively. Two proposed designs respectively have the maximum optical angles of 48.1° and 50.6° at the 20 Vpp driving voltage. Due to the much higher stress on the beam structure induced by the misalignment of PZT film, the actuator could not reach the predicted scanning angle of near 80°. In comparison of the two proposed designs, the straight-curved tapered beam actuator design could enhance the FoM for about 56%. In summary, the performances of piezoelectric MEMS scanning mirror can be improved by varying the designs of length and shape of actuator, and the distribution of PZT film on the suspended actuator is also a critical design concern.