Abstract
This paper describes the application of linear quadratic (LQ) optimal control theory to the design of electronic automotive engine controls. The resulting structure of the control is different from conventional controls in that the accelerator pedal is connected to the microcomputer control rather than directly to the fuel metering device. This strategy is analogous to the "fly-by-wire" aircraft concept. Simulation results indicate that this approach has better engine torque and speed responses to driver commands. This suggests the possibility of improved vehicular driveability. An LQ tracking controller was designed using constant coefficient state variable models (17 states) obtained by linearizing about nomional operating points. Time delays were modeled by first-order Pade approximations. Carburetor throttle blade position, spark advance, exhaust gas recirculation, and fuel flow were defined as controls and output variables include speed, torque, manifold vacuum, fuel and air flows, and exhaust emissions (carbon monoxide, hydrocarbons, and oxides of nitrogen). It is assumed that both engine torque and exhaust emissions are Similarly affected by actuator, intake, and combustion dynamics, thereby allowing the experimental models to be derived from torque response data. Parameter values for the models are derived from measured static data and perturbation frequency response tests about the nominal operating conditions. Simulations show that the optimal design has superior driver command step response performance. Whereas the conventionally controlled lean calibrated engine has a torque sag (suggestive of poor driveability), the optimal design yields a smooth torque increase with no torque undershoot. This explained physically by the fact that the LQ controller slows down the air control loop (throttle) to match line slower fuel control loop dynamics, thereby avoiding the lean air-fuel ratio transients which are the main cause of the torque sag. In addition, the spark is advanced rapidly to achieve the initial torque increase.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.