Abstract
The determination of a pipe bore from the measured reflection function is a technique that has reached a certain maturity. However, the measurement of the reflection function in the time domain (pulse reflectometry) requires equipment that is rather difficult to operate. On the other hand, the techniques for measuring the input impedance have reached an unquestionable maturity with respect to measurement setup and to calibration. It is thus likely that impedance measurements might be able to give the same information. By doing simulations, it is first shown that the reflection function deduced from the input impedance gives access to the bore with a precision comparable with that obtained with pulse reflectometry. It is then shown that the accuracy obtained with measurements is of the same order as that obtained from simulations. The technique is then used for the dimensional inspection of bassoon crooks.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.