Abstract
The subsequent yield surface for an annealed OFHC copper after finite shear pre-loading is experimentally investigated. It was found that when large offset strains or back extrapolation yield stresses were used, the corresponding subsequent yield surfaces were partially or completely outside the von Mises loading surface. On the other hand, the subsequent yield surface determined by the back extrapolation method was close to the Tresca loading surface.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
