Abstract
In the paper, the changes in some mechanical properties and wear behavior of CuSn10 sintered bronze and MMCs based on this bronze reinforced with composite ultrafine aluminide powders FeAl/15 % Al<sub>2</sub>O<sub>3</sub>, NiAl/15 % Al<sub>2</sub>O<sub>3</sub> and Ti-46Al-8Cr are described. It was observed that the presence of aluminides in the MMCs leads to an increase in the hardness, but the flexural strength may increase or decrease depending on the type of aluminide. The presence of aluminides in the MMC reduces the wear rate considerably. It is decreased in the direction of FeAl/15 % Al<sub>2</sub>O<sub>3</sub> → NiAl/15 % Al<sub>2</sub>O<sub>3</sub> → Ti-46Al-8Cr aluminides and for the best MMC composition the advantage is about 20 times. In the MMCs wear process, micro-craters are formed on the contact surface and it is the principal reason of a decrease in the wear rate.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callSimilar Papers
More From: International Journal of Applied Mechanics and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
