On-Probe Sample Preparation without Washes for Matrix-Assisted Laser Desorption/Ionization Mass Spectrometry Using an Anion Exchange Medium

Abstract

When the mass spectra of biological samples (proteins, peptides, and so on) are obtained routinely by matrix-assisted laser desorption/ionization mass spectrometry (MALDI-MS), a serious problem is the reduction of the ionization efficiency by impurities, such as buffer salts and detergents. We focused our attention on devising a method to maintain the ionization efficiency of protein samples, even in the presence of sodium dodecyl sulfate (SDS), without any extra purification step. Although no protein ion peaks are observed in the presence of 2.5% SDS with the usual methods, the addition of a granular anion exchange silica gel to the matrix solution allowed the protein ion peaks to be obtained with an excellent signal-to-noise ratio. Together with other supporting experiments, we suggest that the positively charged surface (the basic environment derived from the anion exchange groups) and the roughness of the particles were important for good ionization in the presence of a high SDS concentration. For a very uneven surface, the SDS might be absorbed into the particle interiors during the process of cocrystallization with the matrix and analytes, which is known as the molecular sieve effect, and the SDS concentration in the surface crystalline film might be reduced. As a result, we developed an on-probe sample preparation method without washes for MALDI, using a strong anion exchange silica gel. This method is applicable even in the presence of 2.5% SDS, and is not only very simple but also inexpensive, because it can be used with the standard MALDI target plates.