On laminar premixed flame propagating into autoigniting mixtures under engine-relevant conditions

Abstract

Usually premixed flame propagation and laminar burning velocity are studied for mixtures at normal or elevated temperatures and pressures, under which the ignition delay time of the premixture is much larger than the flame resistance time. However, in spark-ignition engines and spark-assisted compression ignition engines, the end-gas in the front of premixed flame is at the state that autoignition might happen before the mixture is consumed by the premixed flame. In this study, laminar premixed flames propagating into an autoigniting dimethyl ether/air mixture are simulated considering detailed chemistry and transport. The emphasis is on the laminar burning velocity of autoigniting mixtures under engine-relevant conditions. Two types of premixed flames are considered: one is the premixed planar flame propagating into an autoigniting DME/air without confinement; and the other is premixed spherical flame propagating inside a closed chamber, for which four stages are identified. Due to the confinement, the unburned mixture is compressed to high temperature and pressure close to or under engine-relevant conditions. The laminar burning velocity is determined from the constant-volume propagating spherical flame method as well as PREMIX. The laminar burning velocities of autoigniting DME/air mixture at different temperatures, pressures, and autoignition progresses are obtained. It is shown that the first-stage and second-stage autoignition can significantly accelerate the flame propagation and thereby greatly increase the laminar burning velocity. When the first-stage autoignition occurs in the unburned mixture, the isentropic compression assumption does not hold and thereby the traditional method cannot be used to calculate the laminar burning velocity. A modified method without using the isentropic compression assumption is proposed. It is shown to work well for autoigniting mixtures. Besides, a power law correlation is obtained based on all the laminar burning velocity data. It works well for mixtures before autoignition while improvement is still needed for mixtures after autoignition.