Abstract
The influence of roughness, aperture and asperity irregularity on fluid flow regimes in rough rock fractures was investigated by performing coupled triaxial water flow tests and fluid dynamic computation. Ten sets of fabricated curved wedges were developed to obtain different fracture surface roughness by splitting under compression. Three fluid flow regimes were identified in mated rock fractures: pre-linear flow at low flow velocity, linear Darcy’s flow at the medium flow velocity and post-linear flow at high flow velocity. In pre-linear flow regime, the increasing rate of flow rate increased with water pressure gradient, but it decreased in post-linear flow regime. The pre-linear flow is ascribed to the slippage effect of water-fracture interfaces, while the post-linear flow is mainly due to inertial effects. The critical hydraulic gradient for fluid flow regime transition from pre-linear to linear flow increased with the increase of confining stress. The numerical modeling shows that the asperity irregularity influences the flow regime. For low-speed flow in fracture under slip boundary condition, the slip flux per unit width in the fracture with triangular asperity is largest, while that of rectangular asperity is smallest. For high-speed flow in fracture with non-slip boundary condition, the rectangular asperity element causes more severe nonlinearity when compared to the fractures of trapezoidal and triangular asperity elements.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.