Abstract
In this study, direct metal laser sintering (DMLS) was used to fabricate the functional prototype of a stifel prosthesis. A benchmark was fabricated using 17–4 precipitate-hardened (PH) stainless steel (SS). For industrial use, the process capability of the DMLS fabricated prototypes needs to be ascertained, so an effort has been made to check the process capability by fabricating functional prototypes under the specified printing parameters. Finally, a methodology has been presented for the design, fabrication, and analysis of printed components. The result of this study suggests that the value of process capability indices (Cp and Cpk) is greater than 1. Further X and R bar charts were plotted for statistical analysis.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
