Abstract
Simulated rainfall was applied to runoff plots of four sizes at three sites to generate overland flow. The hydraulic resistance to the flow was assessed using the Darcy‐Weisbach friction factor which was calculated both from direct measurement of discharge and depth of flow and by fitting model hydrographs based on the kinematic wave equations to the rising limbs of the runoff hydrographs. Results show that there is no consistent variation in the friction factor as a function either of plot size or of the method used in its calculation. However, the direct measurement of depth and discharge appears to give more reliable results. Values for the Darcy‐Weisbach friction factor observed here are an order of magnitude greater than those obtained by Abrahams et al. (1994) in experiments on nearby plots but where runoff was generated by flow onto the upper end of the plots from a trickle pipe. It is concluded that determination of friction factors to be used in modeling runoff and soil erosion must be made by direct measurement of flow hydraulics of rain‐induced overland flow rather than from the runoff hydrograph or by using trickle‐induced flow.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.