On-Chip Sensors to Detect Impending Metallization Failure of LDMOS Transistors Under Repetitive Thermo-Mechanical Stress

Abstract

In many automotive applications, repetitive self-heating is the most critical operation condition for LDMOS transistors in smart power ICs. This is attributed to thermo-mechanical stress in the on-chip metallization, which results from the different thermal expansion coefficients of the metal and the intermetal dielectric. After many cycles, the accumulated strain in the metallization can lead to short circuits, thus limiting the lifetime. Increasing the LDMOS size can help to lower peak temperatures and therefore to reduce the stress. The downside of this is a higher cost. Hence, it has been suggested to use resilient systems that monitor the LDMOS metallization and lower the stress once a certain level of degradation is reached. Then, lifetime requirements can be fulfilled without oversizing LDMOS transistors, even though a certain performance loss has to be accepted. For such systems, suitable sensors for metal degradation are required. This work proposes a floating metal line embedded in the LDMOS metallization. The suitability of this approach has been investigated experimentally by test structures and shown to be a promising candidate. The obtained results will be explained by means of numerical thermo-mechanical simulations.