Abstract
The transfer of work material to the tool surface limits the tool life in many forming operations. Using a dedicated load-scanning test equipment with crossed-cylinder geometry, dry forming of austenitic stainless steel was simulated by provoking adhesion to the TiN-coated tool specimen. High-resolution electron microscopy combined with analytical techniques was used to examine the interface between tool and work material. The decisive mechanism for adhesion and transfer of steel to the TiN surface is suggested. The oxide layer on the steel surface, especially the Fe-oxide, initiates the metal transfer. The interfacial oxide acts as a glue between stainless steel and TiN and increases the adhesive forces. Obviously, the adhesion and internal strength of the oxide layer is far stronger than anticipated. It may even be stronger than the bonding to the austenitic steel itself. A consequence of these findings is that the development of galling resistance-forming tool materials and coatings for austenitic stainless steels should not only aim to improve the bulk tool material, but also to reduce the adhesion strength between the tool surface and the oxide layer on the work material.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Microstructure and Materials Properties
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
