Off-road machine controls: investigating the risk of carpal tunnel syndrome

Abstract

Occupationally induced hand and wrist repetitive strain injuries (RSI) such as carpal tunnel syndrome (CTS) are a growing problem in North America. The purpose of this investigation was to apply a modification of the wrist flexion/extension models of Armstrong and Chaffin (1978, 1979) to determine if joystick controller use in oV-road machines could contribute to the development of CTS. A construction equipment cab in the laboratory was instrumented to allow force, displacement and angle measurements from 10 operators while they completed an ˜ 30-min joystick motion protocol. The investigation revealed that both the external fingertip and predicted internal wrist forces resulting from the use of these joysticks were very low, indicating that the CTS risk associated with this factor was slight. However, the results also indicated that, particularly for the ‘forward’ and ‘left’ right side motions and for all left side motions, force was exerted by other portions of the fingers and hand, thereby under-predicting the tendon tension and internal wrist forces. Wrist angles observed were highest for motions that moved the joysticks to the sides rather than front to back. Thus, the ‘right’ and ‘left’ motions for both hands posed a higher risk for CTS development. When the right hand moved into the ‘right’ position and the left hand moved into the ‘left’ position, the wrist went into extension in both cases. Results indicate that neither learning nor fatigue aVected the results.