Abstract
Occupational hazards arising from physical agents present in wood harvesting equipment may cause irreversible damage to the health of exposed operators. Thus, the objective of this study was to quantify the noise and vibration levels emitted by three types of wood harvesting equipment (Feller-buncher, Harvester and Forwarder) in a forestry company in north-eastern Brazil during a workday. Noise measurements were performed with an equivalent noise level meter (audiodosimeter) at the workstation and compared with the limits set in NR-15. To evaluate the vibration was used a full cup gauge, which has a sensor called triaxial accelerometer (directions X, Y and Z), installed on the operator's seat. As a result, the average noise dose of all activities in the operation studied did not exceed the maximum allowable limit of 85 dB (A) for 8 hours of continuous work. The whole body vibration in all equipment was below the exposure level, however, some equipment obtained indexes slightly higher than the alert level, a fact that shows a higher accuracy in the equipment.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.