Abstract
BackgroundOcclusal contact on the implant superstructures is important for successful treatment. The purpose of this study was to investigate the occlusal contact of single implant superstructures at the mandibular first molar immediately after seating from weak to strong clenching.MethodsSubjects were nine patients who had just been fitted with an implant prosthesis in the mandibular first molar region, with no missing teeth other than in the implant region. First, while masseter muscle activity was monitored, maximum clenching strength (100 % maximum voluntary contraction (MVC)) was determined with an electromyogram. Next, occlusal load and occlusal contact area were measured three times at clenching intensities of 40, 60, 80, and 100 % MVC by the use of pressure-sensitive film for occlusal force diagnostic and Occluzer for occlusal force measurement. Finally, the occlusal contact area was measured once each at 20, 40, and 60 % MVC using a silicone testing material and BiteEye for occlusal contact measurement. A two-way analysis of variance (ANOVA) was used to determine occlusal loading and occlusal area as dependent variables, and clenching strength and presence or absence of implant as between-subject factors. A multiple comparison test was performed using the Bonferroni method.ResultsThe occlusal contact area and occlusal load of the implant prosthesis increased with clenching strength, and the increases in occlusal contact area and occlusal load of the implant prosthesis were less than those of the contralateral tooth at high clenching strength. However, significant difference was not observed when compared with both sides of the molar region regardless of clenching strength.ConclusionsThe occlusal contact area of the implant had a tendency to be adjusted smaller than the natural tooth by a dental technician and a dentist. On the other hand, despite the small tissue displaceability of the implant, occlusal load on the implant prosthesis was smaller than on the natural tooth at high clenching strength.
Highlights
Occlusal contact on the implant superstructures is important for successful treatment
There was no significant difference in occlusal load between both molar regions
The results suggest that the occlusal contact of implant prostheses can be evaluated from low to high clenching intensities using Blue Silicone and Dental Prescale
Summary
Occlusal contact on the implant superstructures is important for successful treatment. Methods of quantitative evaluation used to clarify mechanical factors of implant prostheses include pressure-sensitive films for occlusal force diagnostic use and silicone testing materials, but few studies have examined the occlusal contact from weak to strong clenching strength under the same conditions. In this department to date, Okuyama et al [11] used a pressure-sensitive film to examine the occlusal contact and to calculate the mean occlusal gap and occlusal load of implants that had progressed satisfactorily, as well as natural teeth. Imamura et al [12] used a new silicone test material and a pressure-sensitive film to develop a method for investigating changes in occlusal contact from weak to strong clenching intensity in subjects with natural dentition
Sign-in/Register to view highlights & summary Sign-in/Register to access full text options 
Free) 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
