Objective 3D atmospheric front detection in high-resolution numerical weather prediction data

Abstract

<p><span>Atmospheric fronts, a widely used conceptual model in meteorology, describe sharp boundaries between two air masses of different thermal properties. In the mid-latitudes, these sharp boundaries are commonly associated with extratropical cyclones. The passage of a frontal system is accompanied by significant weather changes, and therefore fronts are of particular interest in weather forecasting. Over the past decades, several two-dimensional, horizontal feature detection methods to objectively identify atmospheric fronts in numerical weather prediction (NWP) data were proposed in the literature (e.g. Hewson, Met.Apps. 1998). In addition, recent research (Kern et al., IEEE Trans. Visual. Comput. Graphics, 2019) has shown the feasibility of detecting atmospheric fronts as three-dimensional surfaces representing the full 3D frontal structure. In our work, we build on the studies by Hewson (1998) and Kern et al. (2019) to make front detection usable for forecasting purposes in an interactive 3D visualization environment. We consider the following aspects: (a) As NWP models evolved in recent years to resolve atmospheric processes on scales far smaller than the scale of midlatitude-cyclone- fronts, we evaluate whether previously developed detection methods are still capable to detect fronts in current high-resolution NWP data. (b) We present integration of our implementation into the open-source “Met.3D” software (http://met3d.wavestoweather.de) and analyze two- and three-dimensional frontal structures in selected cases of European winter storms, comparing different models and model resolution. (c) The considered front detection methods rely on threshold parameters, which mostly refer to the magnitude of the thermal gradient within the adjacent frontal zone - the frontal strength. If the frontal strength exceeds the threshold, a so-called feature candidate is classified as a front, while others are discarded. If a single, fixed, threshold is used, unwanted “holes” can be observed in the detected fronts. Hence, we use transparency mapping with fuzzy thresholds to generate continuous frontal features. We pay particular attention to the adjustment of filter thresholds and evaluate the dependence of thresholds and resolution of the underlying data.</span></p>