Abstract
This paper describes the steady state numerical work carried out to study the influence of providing stepped tip clearances at various axial locations along the rotor chord on the performance of the single stage transonic axial compressor. Uniform tip clearance study on compressor under consideration showed performance deterioration of compressor at higher tip clearance of 2mm [3.4% of rotor axial chord] therefore in order to improve performance of compressor, stepped tip clearance method was introduced. Commercially available Ansys Fluent 12.0 software was used to perform steady state RANS simulations with three dimensional implicit pressure based solver and SST K-ω as turbulence model. Stepped tip clearance concept is based on providing smaller tip clearance in front portion and providing higher tip clearance after step above the rotor. In present case, study was carried out for stepped tip clearance with steps at four different axial locations [i.e. 10, 20, 40 & 60 % of rotor chord from leading edge of rotor] and results were compared with baseline model of 0.5 mm [0.9% of rotor axial chord] uniform tip clearance at 100% speed. The stepped tip clearance combinations used for the analysis was 0.5–2mm. It was observed that there was increase in compressor peak efficiency & peak pressure ratio for all stepped clearance cases. A trend was noticed where there was relative increase in peak efficiency as well as peak pressure ratio when step was moved downstream along rotor chord [i.e. moving from 10% to 60% axial location]for one of the combinations stepped tip clearance. Stall margin improvement was observed for all cases of stepped tip clearance. Stall margin gain obtained was higher when step was provided in front portion above rotor [i.e. 10 & 20 % axial location] compared to stall margin improvement when step was provided in rear portion above rotor [i.e. 40 & 60% axial location]. It can be concluded that stepped tip clearance provided near leading edge shows potential in improving performance for compressor under consideration. Numerical analysis of single stage has been carried out but data has been presented for rotor only to study the flow changes occurring in rotor vicinity created by implementation of stepped tip clearance method.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.